Cisco 7970 replacement stand mechanism

prusaprinters

<p>This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).</p> <p>As you can see in the image the original clip disintegrated so I decided to model is in Fusion 360 and print it.</p> <p>There are two versions. The SIMPLE one is easier to print as it doesn't have all the extras but works perfectly fine.</p> <p>I strongly recommend you print this in PETG as PLA is probably going to snap quite quickly.</p> <p> <figure class="media"> <oembed url="https://www.youtube.com/watch?v=u4fYGG51tVU"></oembed> </figure> </p> <h3>Print instructions</h3><h3>Category: DIY Summary</h3> <p>This is a replacement "clip" for the inside of a Cisco 7970 (and any model with the same case).</p> <p>As you can see in the image the original clip disintegrated so I decided to model is in Fusion 360 and print it.</p> <p>There are two versions. The SIMPLE one is easier to print as it doesn't have all the extras but works perfectly fine.</p> <p>I strongly recommend you print this in PETG as PLA is probably going to snap quite quickly.</p> <p> <figure class="media"> <oembed url="https://www.youtube.com/watch?v=u4fYGG51tVU"></oembed> </figure> </p> <h3> Print Settings</h3> <p><strong>Printer:</strong> Anycubic Kossel</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Yes</p> <p><strong>Resolution:</strong> 0.1</p> <p><strong>Infill:</strong> 30</p> <p><strong>Notes:</strong></p> <p>In order for the fine parts to work this needs to printed at 0.1 or better. Also make sure your supports come off clean.</p>