Circuit Board Necklace Hanger 3.0

thingiverse

This handmade jewelry holder transforms used circuit boards into stunning accessories. Dimensions: 20mm wide, 30mm tall in length, expandable to 40mm. It can support board cuts up to 16mm by 23mm or 33mm. Materials needed are a recycled circuit board, a Dremel drill, a hacksaw, and craft glue, plus Mod Podge for sealing. Settings: Print using an M3D Micro printer with low resolution, solid infill, and without rafts or supports. Assembly Steps: 1) Cut the circuit board into desired pieces. 2) Check fit to ensure it's snug in the hanger. 3) Secure with a small amount of craft glue, avoiding any bleeding onto the edges. 4) Apply clear coat for protection after drying the glue according to manufacturer instructions. 5) Attach necklace hardware and chain when the clear coat is dry.