Circuit Board Mounting Tabs

thingiverse

These mounting tabs have a cutout designed for Circuit Playground, featuring a 2" diameter and positioning the board high enough to clip on securely with alligator clips. They measure .4" wide and are easily mounted using M4 hardware. Print Settings Printer: Flashforge Creator Pro Rafts: No rafts were required. Supports: Supports were not needed due to the design's stability. Resolution: The print resolution was set at 0.2mm for optimal clarity. Infill: A 30% infill rate provided sufficient strength and weight. Design Notes This model prints best when positioned on its side, which may cause the mounting hole to sag slightly if supports are not used. However, the clearance hole is loose enough that even with a flat side, the hardware still functions properly.