Circle cutter

thingiverse

While the Circle Cutter design from @RabbitEngineering functions flawlessly, the base of the foot was too broad, which resulted in the inability to see the perimeter of images smaller than the foot base when attempting to calculate their center. This remix incorporates the original foot design with a narrower base diameter. To build this cutter, I utilized: *Cutter 9mm Snap-Off Blade like the one found here https://www.amazon.com/Cutter-Snap-Off-Blades-50-Blade-BA-50P/dp/B001U73LXU/ref=sr_1_3?ie=UTF8&qid=1520867684&sr=8-3&keywords=cutter+blades (only two small segments of the blade are necessary) *2 screws, similar to those used in computer cases for securing the motherboard or power supply, such as these http://www.caselabs-store.com/1-4-6-32-silver-hex-head-pc-case-screws-10pk/ *1 small washer, compact enough so that the screw head does not pierce it Safety note: If the slot for inserting the blade is too narrow, avoid attempting to push the blade with your bare fingers as this could result in a severe cut. Always wear gloves and utilize a locking grip wrench or pliers when pushing the blade into place.