Cinedrony v1.1 - home made cinewhoop 4k

prusaprinters

<p>WARNING: you MUST carefully work on your betaflight filters before flying this drone, otherwise you may burn your ESCs and/or your motors, it happened to me :'(</p><p>The stock configuration created a strong frame resonance at 122Hz in my case, causing the motors and ESCs to overheat. I suppose this is because the frame is less stiff than typical carbon fiber frames.</p><p>Here are my suggested Betaflight configurator / PID tuning / Filter settings:</p><ul><li>lower “Gyro Filter Multiplier” to 0.8</li><li>lower “D Term Filter Multiplier” to 0.8</li><li>setup a Notch filter at 122Hz (cutoff 100Hz)</li><li>setup another Noth filter at 153 Hz (cutoff 125Hz)</li></ul><p>I strongly suggest you use a blackbox to analyze your first flights and make sure there are no vibrations in the motor outputs.</p><p>Once you've done that, the drone will fly really nicely!</p><p>This FPV drone frame is designed to hold this gear:</p><ul><li><a href="https://www.studiosport.fr/controleur-de-vol-aio-reaper-v2-f745-45a-foxeer-a24298.html">Foxeer Reaper AIO v2 F745</a> (any 25.5mm FC should fit)</li><li><a href="https://caddxfpv.com/products/caddx-nebula-pro-nano-vista-kit">Caddx vista with Nebula Pro Nano kit</a></li><li><a href="https://betafpv.com/products/elrs-nano-receiver">BetaFPV ELRS Nano RX</a></li><li>4x <a href="https://store.tmotor.com/goods.php?id=1192&amp;from=rss">T-motor F1408 3950kv</a></li><li><a href="https://shop.iflight-rc.com/iFlight-GOCam-PM-G3-Action-Camera-pro1589">iFlight gocam PM G3</a></li><li>4s battery 850-1500mAh</li></ul><p>You'll also need:</p><ul><li>An ELRS TX like the <a href="https://fr.aliexpress.com/item/1005003824065893.html?gatewayAdapt=glo2fra">Jumper T-Pro with internal ELRS</a></li><li>The DJI goggles</li></ul>