Cigar Store Indian

thingiverse

This is a scan of an Anri Carving made from wood and cork. They are commonly used as bottle stoppers, but this particular one has been modified to stand alone by adding a torus or two using .Mesh Magic. To use it as a traditional bottle stopper, set Slic3r or an equivalent software to sink the stand and 'cork area' so that it is below the print surface. When using Cura, cut off approximately 33mm from the model. After printing, attach a natural or artificial cork to the Anri Carving using hot glue. Apply just enough glue to extend beyond the joint all the way around, then peel off any excess later on. Hot glue works exceptionally well for this task. Print Settings Printer Brand: LulzBot Printer Model: TAZ 5 Rafts: Not Required Supports: None Needed Post-Printing