Chrysler TC Maserati Fuel Door Lever

thingiverse

This piece is specifically made to attach itself to the fuel door release lever on a Chrysler TC by Maserati. To give it enough support, a thin strip of material runs along the bottom edge. This allows you to easily cut this part after it's been printed without needing any custom supports. I suggest printing with PETG or ABS to withstand the heat that builds up inside a hot car. Smoothing out the part with vapor can change its dimensions slightly and might require some adjustments to get the fit just right. If you'd like to make any changes, I've included .sldprt files or .step files for you to work with. For the best slicing and printing results, lay this part down on its side as shown in the picture.