Christmas tree with customizable branches

cults3d

Inspired by the Christmas tree by idig3d, but customizable. This way, we don't all have to print the same tree, which is especially nice if you want to put multiple next to each other. Press the 'Open in Customizer' button above to the right side. Print in vase mode. Bottom layers aren't needed. Be careful with layer heights and the bottom sides of the lowest branches. If you choose your layer height too tall, the branches may suffer from too steep overhangs. I print with 0.16 mm layer height. These overhangs also depend on the way you customize the tree. Check in your slicer. I also included some example STLs that you can produce.