Christmas Tree Decoration

cults3d

Print a Christmas tree with a hidden surprise…push the star to rotate the branches! Can be used as an ornament, decoration or fidget toy. No additional hardware required. Assemble less than 10 minutes! https://youtu.be/9WdTYBxLyyY Assembly Instructions Fit the decorations to the branches—these snap fit into position. Trial fit each of the branches on the threaded trunk half to verify that the branches move freely up and down on the threads. Apply PTFE dry lubricant or similar if required. Remove the branches from the trunk. Push the lower branch part into the bucket. An audible click is made when located. The branch should spin freely. Apply PTFE dry lubricant or similar if required. Fit the middle and upper tier branches by the same means. Taking both halves of the trunk fit the slotted side of the locating key into the trunk half with the shorter recess. With the key in position, gently insert both halves of the trunk through the base—turn the branches as required so they locate on the threads. The threaded half of the trunk should be on the larger side of the hole in the bucket. When in position the narrower trunk half clicks into position. Fit the star to the top of the tree trunk. An audible click is made when located. When assembled correctly, with the tree on a hard surface and the star in its top position, pushing the star down should rotate the branches. Then lifting the tree of the surface should result in the branches rotating back to their original positions under gravity.