Christmas Stocking Hangers

thingiverse

I was looking for something a bit more stylish than tape or blue tack to hang the stockings on the fireplace. So I came up with these weighted Christmas Stocking Hangers. I designed 5 different Anchor variants to avoid repeats on your fireplace: HO HO HO, SANTA, JOY, NOEL and Mix Anchor. The Anchor has been designed with two 30mm diameter voids inside them so coins or washers can be dropped in during the print to add weight, and they all work with the same hook. The Hook is best printed on its side so that it adds inherent strength to the extruded lines and is a nice push fit so no glue is really needed this way; if one gets broken by your little elf, you don't need to re-print the entire anchor. I printed mine in Fillamentum Signal Red / Green Grass with Gold Happens Details. I used the pause at height feature of Cura (I paused mine at 20.5mm high with 0.15mm layer heights) and they turned out great. I printed mine on my CR-10 without any problems at all with either the visible or internal bridges. I hope you enjoy these and if you make any, please post pictures; I'd love to see them. Merry Christmas!