Christmas ornament snowman photo frame

myminifactory

Hi makers! This is my debut Christmas ornament design. I've invested considerable time and effort into this project, but I'm excited to share it with everyone as a free gift since this is my first Christmas upload. It features a slot for a small photo that will require some support. While I haven't tried it yet, the model might print without any support if you have a good quality setting. I'll make sure to update soon. If you're using Cura or Slicer, set the support as 'everywhere' and it should generate supports only in the picture slot area. Removing the support has been relatively easy with a small nose-plier. I've already produced over 20 of these ornaments, and more are on the way, but the model has printed consistently well... not a single failure yet! My recommendation is to print it using neutral-colored filament and color the raised outlines with sharpies (as shown in my photos). However, you're the builder of your own snowman, so feel free to get creative and have fun printing! I wish everyone a very merry Christmas!