Christmas Glass Ball Ornament Protector

Christmas Glass Ball Ornament Protector

cults3d

I needed some protective storage cases for some custom glass ball Christmas ornaments. I was surprised when I couldn't find any models online so I made a super simple solid "hatbox" design. In addition to ornaments, it should be suitable for other knick-knacks, baubles, or bric-a-brac. Or cashews. Whatever. The design is very strong, prints without supports and requires no assembly except putting the lid on. However, the design is relatively slow to print and uses a lot of plastic since it's basically solid. I played around with some designs and came up with an alternative that uses a fraction of the plastic, prints way faster, and has good strength in all directions. Check this model out if a lighter print sounds preferable: Optimized Christmas Glass Ball Ornament Protector To protect the finish of the ornament, I suggest wrapping it in a small sheet of bubble wrap or foam before putting it in the storage box. The inside diameter is 90 mm and the height is 100mm, which is just right for a standard 2.5"/65 mm glass ball wrapped in 1 layer of bubble wrap. Disclaimer : It's your ornament, your printer, your settings, your risk. I hope this model is helpful for someone but use common sense. I'm not responsible if something goes wrong. Please post makes, remixes or comments if this was useful to you.

Download Model from cults3d

With this file you will be able to print Christmas Glass Ball Ornament Protector with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Christmas Glass Ball Ornament Protector.