Christmas Door Trim Corner 63 - Christmas Stocking etc (Christmas ornament)

prusaprinters

https://www.buymeacoffee.com/maxt----------------------4mm thick to ensure stabilityThe model will fit on Prusa Mini+ (180x180)Feel free to size it up or down as you wishI strongly suggest sizing it up to fit your entire heat bed as it gives the best resultThe best quality is achieved if printed face downPrint: 0.2mmNozzle: 0.4mmSupport: Not neededBrim: Not neededInfill: Not needed, but I'd suggest going with 15% to ensure sturdinessA tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :) Happy Printing!--------------https://www.buymeacoffee.com/maxt