Chompy, The Filament Shark

prusaprinters

<p>Chompy, The Filament Shark cuts the ends of your filament leaving a nice 40º shark bite across the end of the filament. Chompy doesn't leave filament ends everywhere, and has a big stomach for holding many filament ends.</p><p>When Chompy is full, just lift the (magnetically latched) fin to let it poop all the waste filament into the bin.</p><p>This is a relatively simple print. No support required.</p><p>You can see Chompy in action here: <a href="https://www.youtube.com/watch?v=lVJGpDeQzrk">https://www.youtube.com/watch?v=lVJGpDeQzrk</a></p><p>You need:<br>2x 10mmØ x 3mm thick magnets<br>30mm m3 nut and bolt<br>12-16mm m3 nut<br>A spring, around 5 - 6.5mm Ø and 15-20mm long.<br>A 9mm box cutter blade - available from most hardware stores (https://www.amazon.com/Amazon-Basics-13-Point-Carbon-Blades/dp/B08D9Q796F)<br>A dab of superglue in case the blade is a bit thin and doesn't want to stay in place.</p>