Chiron BMG Extruder Adaptor

thingiverse

This is a small adaptor that moves the position of the filament sensor so that its inline with my new BMG extruder china clone (which works great!). I've made it a tight fit so the sensor just pushes in and no need for screws. I suppose it could be a problem if you push it in too hard but I'm sure your not simple ;) For those wondering about the BMG extruder I just grabbed one off ebay which was a china clone. I had to place the stepper motor on the top of the bracket with the extruder below. . As the BMG extruder is backwards driven you have to reverse the stepper driver wires. Use the supplied screws with the BMG extruder, and the little screw on your chiron. Just attach the little screw directly through the bracket into the stepper motor and the extruder sits over the top of it. Then use the three long screws supplied. Make sure you print this standing upright. Make sure to calibrate your extruder after this mod