Chipsticks v2

prusaprinters

This is the v2 after less than 24 hours posting of v1. It should be much better when used to pick small and light snacks like potato chip, beans, French fries, etc. Learnt from v1 that the tabs at the back of the fingers are not needed. Removing it makes a clean design. Print Settings Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: No Resolution: 0.2mm layer height Infill: 0% Filament: No Brand PETG Clear Notes: Two walls with no infill. I used 0.6 nozzle and the line with is 0.6mm. As always, check you slicker before print. My Cura prints broken inner wall on some layers. New beta engine solves this problem but I choose to use a slightly thinner inner wall of 0.56mm to solve the problem. If you filament is dried and flow is accurate, it should be printed without any stringing issue or blobs. Category: Hand Tools