Chimera + cyclops + i3 X-carriage mount with BL touch

thingiverse

I went searching for a decent X carriage for the Chimera+ and couldn't find one, so I built my own. It will also work with the Cyclops+. Note: This will only work on the new Chimera+ and Cyclops+, if you have an older version ("pre +" doesn't matter), this won't be compatible. I've been enjoying my design, but there's a downside - accessing the tubes is more complicated than I'd like. My old Chimera clone had pneumatic fittings that stuck out of the holes, making it easy to remove the bowden tubes. The official E3D Chimera+ has fittings inset into the carriage and you have to take the whole thing off to access the tubes. It's not a huge deal, but I might change it later. I printed mine in PETG because the temps can get pretty high and deform the fan duct if you use PLA. Meant for 45 mm linear rod spacing.