Cheshire Cat 8x3mm Magnet Inserts (for parts body_6 & body_7)

thingiverse

This is a straightforward remix of two sections you can swap out for the full-sized assembly version of Cheshire Cat, replacing the two parts that use the "body bump" files instead. There are four hole cutouts in two sections of the body where you slip 8x3mm rare earth magnets to create a way to easily store stuff in a little hidey-hole. I used whatever 8x3mm magnets I found on Amazon, nothing special, and they fit well, completely flush with the surface so you can't tell when the parts are stuck together that there is any gap. I would say its a "close to flawless" alignment (you can be the judge by the second picture). I had to design it in Tinkercad, but I truly can't tell which part of the model comes off when the magnets are on, so I think I got it about as close as anyone will need. The holes themselves are 3mm deep and 8.15mm in diameter to accept the magnets; a dab of glue is needed on each magnet so one side doesn't pull the other side out when you separate the pieces. Just make sure you triple check the orientation of your magnets before gluing them so they don't repulse each other by accident. Also, note that the assembly graphic says parts 5 & 6 with body bumps are actually parts 6 & 7 just FYI --- there's a little tiny piece near the tail that can't be seen from the picture orientation so I think that's how it got mislabeled).