Cherry MX keycap to low-profile Kailh Choc switch adapter (Havit Keyboards)

thingiverse

Check out the updated rebuild here: https://www.thingiverse.com/thing:4747233. The original design didn't fit my Havit keyboard properly; the legs were a bit too close together and short to fit and stay in the switch, I understand this is a slight difference to low-profile choc switches on Havit keyboards. ### Changes: - Made MX end thicker for tighter keycap fit (no longer comes off with a sticky finger on press) - Spread and lengthened legs on the choc end for a fuller, closer fit - Minimized footprint of intermediate piece; with a wide profile it couldn't sit flush in the switch I used PLA initially, which feels sturdy enough, but I can confirm PETG works well too (albeit a bit stiffer). The tolerances are really small; I got the best/most consistent results printing with the MX side facing down (with supports) and choc side up. I also printed at 0.05mm, but there didn't seem to be any benefit to doing so. Be careful removing supports. I've also included "Alternate-Cherry-MX-keycap-to-low-profile-Choc-switch" which closer matches the legs on the Havit keyboard keycaps. I was able to print in PLA but the thinner part of the legs were too fragile and snapped when inserting into the switch, YMMV.