Cherry 3D Printer X_-_Carriage NEMA16/NEMA17 Motor Adapter

thingiverse

Little adaptation to install Nema16/Nema17 motor in X-Carriage using same screws from X-Carriage to fix the 28byj-48 Stepped motor and 624 Bearings. The holes to screw from Nema16 and Nema17 are the same spacing. If your motor shaft is more than 20mm longer, perhaps you will need to add thickness between the motor and the support. I added a new piece to add things between Motor and Adapter if you motor shaft is too long. It's a plate 2mm thick. You can scale in the Z axis to add or remove thick. You will need change the screws from your motor by other longer to go through your motor and this piece. To mount: Put four M3 hex Nuts in this piece. Screw this piece to X-Carriage with same screws and bearings. I added some washers to adjust the bearings position. Screw your motor to this piece with new long screws, from back of the motor. Printer Settings Printer: Cherry 3D Printer Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2 Infill: 20%