Cheap Camera Slider

prusaprinters

<p>This design uses 14mm diameter metal rods (recyled from old furnature) as a guide rail for a camera slider. The design includes a holder for the rods, which must be placed at both ends and a top part where the camera sits, which has a place for an M6 screw to mount to a camera.</p><p><strong>BOM:</strong></p><ul><li>2x14mm diameter rods</li><li>8x603ZZ bearings</li><li>8+4 M3 screws</li><li>1 M6 Screw (optional, you can mount the camera any way you like)</li></ul><p><strong>Print instructions:</strong></p><ul><li>Print flat</li><li>Print 2 holders and 1 top part</li></ul><p><strong>Assembly:</strong></p><ul><li>Place the 14mm rods inside the holes, tighten clamps if needed</li><li>Install 8 603ZZ bearing on the top part with M3 screws</li><li>Place the top part on the rails</li><li>Mount camera, enjoy the videos</li></ul>