Chasis Simple Impreso en 3D

thingiverse

This project is about a simple 3D printed chassis that I made as a test base for a robotics platform. I tried to make it with as many non-printed parts as possible, in order to maximize the number of people who could use it. I printed everything in ABS plastic, and it has held up well - no broken parts yet !. Uses This chassis could be used as a simple RC car, or for some robotics platforms (I built it to test image processing with a Raspberry Pi). Also, with its high speed, this could even be used to run another robot! Limitations Since it only uses a one-stage gearbox, this bot is FAST. Once the gears wear out, it can run without problems at low voltages, but it doesn't have much torque to pull weight or drive slowly. This base is also very short and wide, as the application I designed for it required that. If too much weight is added high up, it may become easy to tip over. However, it can be easily straightened out. In fact, if you put all the control electronics next to the motors, and not on top, this robot could flip over and still keep working well. Follow the project at https://www.todossomosmaker.com/inicio/impresion-3d/chasis-simple-impreso-en-3d