Chaser's Practice Rig Designs for Street League

thingiverse

streetleaguespec Here is a collection of STLs that I used on my PRIG build. FILENAME Description Print Instructions 20x20 front mount v1 Adds 20x20 mount to the front. Does have some risers because I thought I was going to mount my ELRS RX underneath. I used it to mount a Tinysleds Infini Rainbow LED PDB (4-wire) 20x20 rear mount v3 Adds 20x20 mount to the back and leaves space for 2 12AWG battery wires. I used it to mount my HDZero Race V2 VTX, and then a Tinysleds Infini Rainbow LED PDB (4-wire) Print 1 as is, and then print one mirrored. 45 degree session mount Front load 45 degree session mount Print on the side that would normally be the back of the gopro arm guard V4 This is protection at the end of the arm without the extra motor protection Print on the flat side. You will need two in the normal orientation, and two that are mirrored. arm guard V5 This is the same as V4 but with extra motor protection. Print on the flat side. You will need two in the normal orientation, and two that are mirrored. battery tray back v1 This mounts to the bottom of the PRIG and fits the RDQ battery. It attaches using four of the screws from the back arms (2 on each side). battery tray front v1 Same as the back version, but for the front. After printing both, there is room between them to run a battery strap elrs 2p4g antenna mount This will mount to the front or back standoffs. it was made to fit the antenna that came with the AxisFlying Thor RX hdzero runcam micro v1 cam mount This mounts the V1 HDZero micro cam at a 45 degree angle new axii 2 mount prig with elrs This will mount an Axii 2 antenna to the back standoffs. It has a cutout to allow the elrs antenna mount to nest underneath new axii 2 mount prig This will mount an Axii 2 antenna to the back standoffs. Arm protection V5 This is the print that the arm can slide into. You do have to remove the arm to install. The print is reversable so it fits on all arms, with room for motor wires and Tinysleds PRIG LED panels on both sides aswell. Print on the flat side, nearest the motor top plate back fin v1 This is just a turtle fin for the back