Chasecam

thingiverse

Chasecam for paragliding or paramotoring requires 8 fins attached to the front. These fins are secured with tiewraps that tie each other together and to the front. A Gopro attachment is stuck to the front and held in place by a 4mm screw. The hanging line is connected at the balance point on either side, rather than the top. A small notch was filed into the fins where the lines pass through, preventing them from shifting. This chasecam is printed with ABS plastic, which can be easily replaced if it breaks on a cold winter day by reprinting it with flexible filament. Settings for this print include: Layer height of 0.2mm Side, top, and bottom thickness of 1.2mm No supports are necessary Infill is set to 50% The print speed is 60mm/s No cooling is applied during the printing process.