Charging phone stand

prusaprinters

This is a 3d model of a phone stand that can stand and charge at the same time using the charging brick as a holder for the phone stand. The model consists of two parts: the base and the holder. The base has a slot for the charging brick and a hole for the cable. The holder has a groove for the phone. (Please leave a comment or use my discord to say if i need to change things)Print SettingsFilament: ABS or PLALayer height: 0.2 mmInfill: 10%Supports: YesRaft: NoBrim and skirt: OptionalOrientation: The model should be printed vertically, with the holder facing up and the base facing down.Assembly InstructionsThe charging brick can be put through the big hole in the base, and the cable can be put through the small hole and plugged into the phone. The phone can be placed into the holder and made to stand.TipsIf the printer is too small, the model can be sliced into two parts along the holding place and printed separately with no supports. (If the printer isnt that good then use support for the curvy edges.)