Charge controller holder + LED volt meter (solar)

thingiverse

Here is the spun content. Printed Holder with Volt Meter for the Solar Charge Controller https://www.thingiverse.com/thing:924112 \nPrinting Information\nPrinter Type: HARDON ORD BOT\n Rafts:\n None Required\n Supports:\n No Need For Any Supports\n Resolution:\n Set To 030 Quality\n Infill Level:\n Set At 20%\n Editing Notes:\n You can freely modify the SCAD file to personalize both components in size and number.\nPrint using PLA. \nRequired Materials After Printing\nLed Volt Meter (amazon or eBay module) Component Push Button Switch Component Velcro Strips for Secure Mounting Lengths of Red and Black Wires 4 Half-inch screws Assembling Your Project Print both components. Attach the solar charge controller to the base using velcro strips. Install the led volt meter into its designated slot. Connect the push button switch according to the wiring diagram inside the volt meter box. Connect red wire to positive battery terminal in charge box unit and red wire's other end to another screw post on switch board. black (-) wire from the voltage gauge to negative terminal in charge unit.