Chaos Claws for Cr10s Risers

thingiverse

I'm just getting started with modifying stuff in TinkerCAD. The "yellow dot" squash balls really toned down the printer and reduced the vibrations a lot. I printed them using a 0.6 nozzle, .218 layer height and three layers for the walls, four for the bottom. They feel pretty rugged overall. I added a small dab of rubber glue to the balls to keep them in place. The hardware consists of just sixteen 4mm x10mm screws with t-nuts attached to the twenty by forty mm rails underneath the frame so they'll fit on any frame with those as the primary base. I made these for my Cr10S so I could put the controller under it and 42mm squash ball feet should quiet it down and help with vibrations. But in the end, I opted for the shorter legs instead. I took the feet from https://www.thingiverse.com/thing:2880796 and added spiked legs to them. Autopsy Turvy created some sweet looking claws. Thank you very much, Autopsy Turvy!!! This thing was made with Tinkercad. You can edit it online at https://www.tinkercad.com/things/1je1P8Hkntb