Channel Slot

grabcad

Mass = 1122.85 gramsVolume = 153815.28 cubic millimetersSurface area = 32383.21 square millimetersFirst, I started making the channel slot through the right plane. Secondly, I had the right plane sketch extruded to 130.5mm. Third, I did an extruded cut by 3.5mm on both the front & back of the channel slot. Then, I did another extruded cut on the center piece of 30.5mm. On the fifth step, I used the chamfer tool and used a distance/angle chamfer of 45 degrees and 26.5mm. Then, I sketched and used an extruded cut on the dented edge on the back of the model (10mm x 15mm, through all). Next, I created the channel slots with a width of 44mm, and a length of height of 11mm. I made sure the channel slots were both aligned in the middle of their respective area, and set to a distance of 30.5mm from the back of the model. Finally, I used the fillet tool on the slots to 2mm on both the front and back of the model.