Channel Slot

grabcad

>First, I started by sketching on the front plane, the top and bottom rectangles to 95X104.>Next, I made a center rectangle in between the top and bottom rectangle, made a small line on the left side of the whole design, added angled lines to make it 45 degrees for the top and 315 degrees for the bottom rectangle. >Then, I added boxes in the top right and bottom left corners and I trimmed the rectangles to the shape of the blueprint.> Afterwards, I created the two slots in the middle of the top and bottom rectangle, smart dimension the outer slot and made another slot inside the first one. > Next, I extruded the bottom rectangle, then the middle rectangle to 6mm. After that, I made another plane that was 8mm that extruded my drawing.>Then, I had to outline my drawing in order to extrude the rest of my drawing. I also had to make another plane to 8mm to extrude more of my drawing.> Afterwards, I had to make another plane to 8mm to extrude and finalize the rest of my drawing.>Lastly, I changed the material to Cast Alloy Steel and measured the mass. I had to re-evaluate my mass.