CHANDELIER - PRUSAMENT SPOOL - reuse idea

myminifactory

Follow the official blog post: https://www.prusaprinters.org/?p=8875&preview=true. First, 3D print the parts and warm up the hot glue gun. To begin, you will need the R1 parts, which have a middle partition and are orange in color. The sides with one dot should be placed inside the first tube, which is the first row. Position them around the tube at 60-degree intervals and secure them using a hot glue gun. Next, glue another six paper tubes (the second row) around the central one. These six tubes are vertically secured with R2 parts, which are green in color and have symmetrical sides. There are no special requirements for their position. The next step is to place R3 parts, which are blue. Each tube of the second row contains two R3 parts, each with two dots on one side. The side with the dots should be placed inside the tube. Then add another six tubes (the third row). You will then need to place R4 parts, which are red and have three dots on one side. There are two R4 parts in each tube of the third row. The lower part of these parts directs upwards, so make sure they are positioned correctly. Finally, you are ready to add the last fourth row of six tubes. The body is now complete. The next step is to prepare the wire and bulb. Choose a switch, light bulb socket, light bulb, and outlet plug that fit your country's system. When installing the cable through the top part, leave a couple of centimeters at the end so the bulb socket is not directly under the 3D printed part. If you place it too close, the plastic will be damaged by heat. Secure the wire with a screw, and don't forget to protect it with a 3D printed cable protector. Press the top element into the top tube using glue if necessary.