CHANDELIER - PRUSAMENT SPOOL - reuse idea

cults3d

Follow the official blog post: https://www.prusaprinters.org/?p=8875&preview=true. First, you need to 3D print the parts and heat up a hot glue gun. The first step is to assemble the R1 parts (middle partition, orange ones). Place the sides with one dot inside the first tube (first row) in 60-degree steps and secure them with a hot glue gun. Next, attach another six paper tubes (second row) around the central one. These six tubes are vertically secured by R2 parts (green ones), which have symmetrical sides and no specific placement requirements. Now, add the R3 parts (blue). There are always two in each tube of the second row. They feature two dots on one side; this side must face inward. Then, attach another six tubes to create the third row. Next, place the R4 parts (red ones) inside the tubes of the third row. These parts have three dots on one side and are asymmetrical, sloping downward with the lower part facing upward. Finally, add a fourth row of six tubes to complete the body. To proceed, prepare the wire and bulb. You can choose your preferred switch, light bulb socket, light bulb, and outlet plug according to your country's system. When installing the cable through the top part, leave some space for the bulb socket; otherwise, the heat may damage the 3D printed part. Secure the wire with a screw and protect it with a 3D printed cable protector. Finally, press the top element into the top tube using glue if necessary. Check out the following resources: https://www.dominikcisar.cz, https://www.model3D.cz