Champion's league cup - text ans symbol

thingiverse

This is a design for adding the UEFA symbol and text to the cup model found at https://www.thingiverse.com/thing:319038. The design is for a trophy with an overall height of about 23 cm, which is the same as the original cup in the link above, scaled uniformly by a factor of X675. The symbol and text were not scaled. I designed this model after searching for a cup with engraved text that didn't turn out well. I thought it would be better to print it alone, and it was. Instructions: * Print it at the lowest resolution possible (above 0.1mm will result in significant detail loss). * Print it laying flat (rotate 90 or -90 degrees from the original position). * Print it slowly - I used a 15 mm/s profile on Cura. When attaching to the cup, use UHU all-plastic adhesive, which allows several seconds for adjusting before it is fixed. Attaching letters was tricky. First draw a line (I used a long piece of tape) to mark a straight row, then glue each letter by hand. I tried using UHU all-plastic but it was very difficult as the glue is very viscous and can be applied to such a small surface without residue, so I went with Gorilla Super Glue, which still had about 10 seconds for alignment. The apostrophe above the E in "Europeens" was too small to print well, so I designed a 0.8X0.8X6 mm box, printed it, and cut it to the desired size. I'm attaching the Fusion 360 file for the text; you can edit the sketch there to whatever font and style you want (what I used looked closest to the original). Enjoy!