CH Products Flight Yoke Clamp Extension

thingiverse

Many people struggle with the clamps on the standard CH Products Flight Yoke. The upgraded Eclipse Yoke comes equipped with clamp extensions that make securing your yoke to your desk or table a breeze. I took precise measurements using one of these extensions and created a model that closely replicates it, allowing you to use it with the standard CH Products Flight Yoke. I designed this setup to be printed on the side, which has worked perfectly for me so far. You may need to experiment to find a better approach, but with this method, you won't have to adjust your backlash since the hole prints vertically. This print fits snugly within the small print area of the M3D Micro. You'll need to remove the support material attached to the two tabs in the middle. The other longer slots may not require removal of their support material. The two protruding tabs might need a bit of sanding to fit into the existing clamp piece, depending on your printer's configuration. This worked flawlessly for me, and I hope it will work equally well for you!