(CF1-AP280) FOOT, COMPUTER CASE, ANTEC P280

thingiverse

This custom case foot was designed to swap out the standard one because the large Antec P280 case kept sinking into carpets and cutting off air supply to its power supply. Check out this info video at the SBS Extensions YouTube Channel. Print Settings Rafts: None needed. Supports: Don't need them either. Resolution: You can use any setting you like. Infill: Use whatever percentage you prefer. Suggested printing settings: Print without a raft, don't use supports and use an infill % of your choice. Using three shells is recommended if you're not printing at 100% infill. Note: The STL file has been saved with the printing orientation set for the lowest number of supports needed to print this object. This case foot was designed for ABS filament but works differently with PLA due to different tolerances. The central hole fits a standard M5 screw and some other screws that have a similar thread type such as #10-24 UNF or #10-32 UNC, minimum recommended screw length 11mm which is about .5 inches. This will also help make the hole easy to thread a screw into. Also note there's 0.3 degrees of draft on this screw hole which helps make it easy to insert a screw into. And tapping M5 threads into that hole makes threading the hole with your hands without using a tap, super simple. There is circular cut out underneath where you can put in an old factory part made of silicon rubber that holds it firmly.