Cetus Z-Axis Stiffness Bracket

thingiverse

This bracket provides added stability to extended Cetus printers mainly, but it can also be beneficial for standard height models. It keeps the sprag bearing on the motor shaft in place to slow down a falling print head. To install this bracket, you need to drill out one threaded M3 hole that was previously occupied by the rubber foot. You might have to move the entire vertical aluminum extrusion slightly to get it to the correct height. Perform a bed calibration after installation. Additionally, you will require: * 3 M3 nuts DIN 934 * 2 M3x8 bolts DIN 912 * 1 M3x12 bolt DIN 912 * A 3 mm drill bit