Cetus Bed Leveler

thingiverse

Hi there, I've got my design for a bed adjuster for the Cetus 3D ready to go. The main goal was to avoid drilling any holes into the printer itself and keep intervention to an absolute minimum. I'm providing two files - one ending with "S" requires supports and needs them tweaked within the Cetus software to prevent supports from getting stuck inside the holes. On the other hand, the file ending with "No_S" doesn't need any supports at all. To assemble this bed adjuster, you'll need eight M3 nuts, four M3-20mm screws, four springs (with an inner diameter of 6.5mm, outer diameter of 9mm, and a length of 15mm), one rubber band, and four M3 anti-slip washers. I hope this design is useful for you! If it turns out to be something that helps, I'd appreciate any donations you'd like to make - just visit paypal.me/3dpMaker.