Cervelo S3 Garmin Mount

prusaprinters

A print for the Cervelo S3 Specific Garmin mount.  Printed in ABS with a 30% infill.  Uses a small threaded brass insert that should be inserted using a soldering iron for best results.  Please use thread locker on the single M3 bolt.Safety WarningMake sure the T-piece (stem side bracket) is sub flush to the stem bracket using a straight edge and adjust the print or file away material until it is 100% perfect.  If your printer is accurate then this print should be ok but please check.  If the print is higher than the bracket it could/will crack your carbon bars which would be dangerous!Also make sure that the M3 bolt you us is not so long it pushes through the T-piece and into your carbon bars.  This will crack your bars which would be dangerous!