centrifugal pump compact reservoir

thingiverse

modeled this to add onto the end of the centrifugal pump design as i had some spare motors laying around turns out both were dead when i went to test it so i ordered a pump online as the pump was cheaper then the motors i had plus i could get one in a fraction of the time. this reservoir/pump was going to be used to water cool a hotend. feel free to try it yourself you will need to model a cap for the top filler or use a qtip as that has a tight fit and fill with a syringe. also use a gasket that has been remixed before and the outer diameter of the barbs fit a 8mm hose be very careful when taking off the supports as they can easily rip the barbs as it is only one layer (my mistake changing it breaks the model) but if your supports come off cleanly then they are definitly strong enough.