Celestron 114AZ finder scope rail picatinny

thingiverse

Used Baelyn's design for the base design however the 114AZ has little nuts on the top of the telescope body preventing a flush install and also the thumb screws from the telescope competed with picatinny rail for space. Cut out an area for the nuts and offset picatinny rail so that wasn't an issue for the 114AZ. Note: curve is a little off for this diameter telescope but close. I ended up using a few layers of electrical tape on the bottom of the adapter like a gasket. Foam tape, thin piece of rubber, hot glue might also work.Personally I printed as orientated (in the STL) with default supports from Cura. Printed in 0.6mm (for speed) and a brim...because you should always print a brim ;)The red dot is just the el cheapo style I think every gun owner has in their junk drawer.