Ceiling chandelier

thingiverse

Hello all, In this project i tried to design chandelier with all parts fully printable on 3D printer. There is a list of parts with their quantities which will be neccesary to print in order tu complete assembly. I´m also adding link on sleeve for light bulb which I´m using in this design. 1x Podstava 2x Bočnice 1 2x Bočnice 2 1x Vrchní část 1x Šroubení 1x Baňka 2x Úchyty 2x Kolík (STL file contain 8 pins - neccesary quantity is 16 pcs.) Regarding to assebly, I reccomend, firstly print all parts and then do a assembly tryout. If everything will be allright, you can continue with gluing and conecting each part. I personally used superglue which i put on pins and also on conecting surface of parts. After assembly it will be neccesary to drill holders (úchyty) to the ceiling (pitch between holders have to be chosen according to part “baňka”). You should be able to put this part on holder and with simple turning should be possible to lock position. Last part will be conecting of electrical cables. It is not so complicated. Much more complicated will be read this procedure which was wrote with my czechenglish.. But in any case if you have any question you can leave me here a comment or you could send me message directly on my email : marasig@seznam.cz Link on sleeve for light bulb : https://www.ledakce.cz/e27-objimka-zarovky--termoplast--bila/ Hope you will be satisfied with this model. In case you would like to support me with my designing work, then you can on link below : https://paypal.me/marasig?country.x=CZ&locale.x=cs_CZ