CEG Extreme remix face mask frame, easier to print and to use

thingiverse

I'm really impressed with the original design - it's not flashy, but it GETS THE JOB DONE! However, I did notice that it had some flaws. It was prone to breaking in certain areas, and there were a few things that could be optimized. Here are the changes I made: * I increased the size of the base of the spikes, which also made the spike head easier to print without supports (especially for the spiked model). * I tweaked the design so that the two walls of the rapid latch on the lower band are slightly farther apart, making it easier to pass the band through without having to pull too hard. * I rounded out the tops of those walls and shortened/enlarged the base to make them even stronger.