CCI Phantom Paintball GoPro Session 5 case mount

thingiverse

In the thing files are 2 different ways to mount your GoPro Session 5 to a marker. The first three files are specific to a CCI Phantom with a vertical feedneck and collar. The last one is a more universal barrel mount that can be used with any gopro. I remixed the rear mount case from somewhere, but couldn't find the source file. Print the case and mount in PETG and the leg and barrel mount in TPU. You will need a small screw to attach the leg to the case if desired. The mount will work without it, but may be less stable. The first half of the video is using the phantom feedneck mount, the second half is using the barrel mount. https://youtu.be/f1yjOIeapGE?feature=shared 1. Rear mount gopro case: Fits HERO Session 5 and was remixed to fit with the mount I created. The mounting holes line up really tight and I had to thread the bolt in. I used an M5 bolt and nut here. Use an M3 screw and nut to tighten the case. *UPDATE* I finally got to use this on the field and the button was really hard to press with the small hole cutouts. I updated the design with a big box cutout (V2). *2nd UPDATE* I used the v2 on the field and it worked GREAT!!! 2. Phantom Feedneck mount: Specific to a CCI Phantom. Print in PETG with a high infil. Take off your vertical feedneck collar and replace it with this mount. Use an M3 screw and nut in the feedneck collar and an M5 screw and nut for the GoPro mount. If you print the leg, you will need to screw it in before putting in the GoPro. 3. GoPro Case Leg: Optional, but will increase the stability of the GoPro and maybe reduce chances that you rip the single little screw holding your feedneck to your body out. Worth it in my opinion. Print this from TPU. I used a brass #4 1/2 inch screw here. Don't screw the tip of the screw into your barrel. 4. Barrel GoPro mount: Print this in TPU. I have only tried it on a few barrels but it seemed to work just fine. Use 2xM3 screws and nuts to clamp the mount together and an M5 bolt for the GoPro. I could have made new thing for this one...but I'm too lazy. *UPDATE* I ran this on the field on a CP barrel and it worked great. I think it needs a remix for a larger diameter barrel though, as it doesn't fit on old school Freak backs. I'll work it. This works better on smaller OD barrels, .85" 5. Barrel GoPro mount Large: Use this for one inch OD barrels such as the old school Freak back.