CC2530 Router USB Enclosure

thingiverse

A simple housing for a CC2530 zigbee router flashed with the Zigbee2MQTT router firmware. This enclosure is designed to fit snugly over an old Apple USB charger, utilizing a DC 5V To 3.3V DC-DC Step-Down Power Supply Module to provide 3.3 volts to the CC2530. I cut the USB plug off an old USB memory stick and soldered the GND and V-IN pins of the Step-Down Power Supply Module, then connected the GND and V-OUT to small jumper wires which were connected directly to the CC2530. The CC2530 slides smoothly into the enclosure and is securely held in place by the antenna and a small ledge that supports the PCB. The enclosure friction fits perfectly onto the USB charger. This project was based on the Zigbee2MQTT router instructions found here - https://www.zigbee2mqtt.io/how_tos/how_to_create_a_cc2530_router.html