[CC-01] 2S Brushless Whoop

thingiverse

The primary objective of this design is multifaceted. Firstly, address known issues with CC-00 by utilizing the whoop form factor to provide enhanced protection. Secondly, investigate the feasibility of using PETG as the material for printing the frame. # Features 1. Can utilize a 16x16m flight controller stack or a typical 36x36mm whoop FC. 2. Offers adjustable camera angle ranging from 0-45 degrees. 3. Provides flexible battery mounting solutions, allowing additional 1S batteries to be added using more **battery holder** components (Please note the voltage limit of FC and ESC). 4. Utilizes M2 screws and nuts exclusively. 5. Easy to print, with only the frame requiring minimal support. # Specifications * Motor: RacerStar Racing Edition 1103 BR1103 10000KV Brushless Motor * Propeller: RacerStar 1535 38mm 1.5mm-hole 4-blade propeller * ESC&FC: HappyModel Super_S F4 2S 16x16mm Flight Controller + BLHeli_S 6A ESC * Camera: Caddx EOS2 * VTX: Runcam TX200 * Receiver: FS-RX2A * Battery: Team Black Sheep Graphene 260mah 1S HV **Note:** Frank Zambrana has successfully tested the frame with crazybee F3. # Known Issues 1. No direct access to the USB port. 2. Direction of VTX antenna is not ideal. 3. The PETG frame may not be tough enough for hard crashes. 4. Currently does not support smaller motors (e.g., 0603, 0705, 0804). # Update Log * 2018-11-11 23:47 NZDT: 1. Uploaded **cc01_battery_holder_v2**. 2. Uploaded **cc01_battery_base_v2**. 3. Updated the picture of battery mounting solution. * 2018-11-15 14:50 NZDT: 1. Uploaded **cc01_frame_v2**. 2. Updated the image showing total weight. 3. Updated the image showing battery pad.