Cave for Centromochlus perugiae / Tatia perugiae (honeycomb catfish)

cults3d

This is a cave for Centromochlus perugiae / Tatia perugiae (honeycomb catfish). They love it when their cave is near the water surface. There are two versions: Version 1: There are some loops so you can fix the cave with some cable ties or something like that. Version 2: There are some holes so you can bring in some magnets to fix it on the wall. I recommend to glue the magnets into the holes (use suitable glue!). It needs four magnets, I used this magnets: "Zoomed MagClip (Magnet Suction Cups)". The clips of this magnets are not needed. Version 2 also have some smaller caves for young catfish or shrimps. The whole model have to be a litte bit thicker to be able to sink the magnets in it. So I used this unused space to incorporate these small caves. If you print one of this version with a rough surface, some moss can grow easier on it. Each version have seven caves (three in front and four in back). This is a cave for Centromochlus perugiae / Tatia perugiae (reticulated catfish). They love it when their caves are placed near the water surface. There are two versions. Version 1: It contains loops so that the cave can be attached with cable ties or similar. Version 2: It contains holes for which magnets are provided. In this way, the cave can be attached to a wall. I recommend gluing the magnets into the holes (please use suitable glue!). It needs four of the magnets, I used these magnets: "Zoomed MagClip (Magnet Suction Cups)". The clips of these magnets are not needed. Version 2 also has small caves for young catfish or shrimp. The entire model had to be made a little thicker to allow for the magnets to be recessed inside. I have therefore equipped the resulting unused space with small caves. If you print one of these versions with a rough surface, it will be easier for mosses to grow on it. Each version has seven cavities (three in the front and four in the back).