Cat Off Device

prusaprinters

<p>You know those things that cities install on signs and buildings to keep pigeons off? This is that, but for cats, and for very specific situations where you've got vents of the perfect size atop your device.</p> <p>Specifically, I think, amps.</p> <p>My cat loves sleeping on my amp. It's warm and cozy, but the problem is that it isn't able to vent when she's atop it, and it needs to vent to work, especially in the summer.</p> <p>This was specifically printed for the Pioneer VSX-933, but I suspect it'll work for a lot of amps, since they tend to have a similar vent configuration.</p> <p>I printed three out and it's enough to keep the surface from being uniform, thus dissuading my cat from squeezing up there.</p> <p>I doubt anyone will ever find use for this device, but I figured I'd share, since I took the time to tweak it.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Monoprice</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Maker Select Plus</p></div> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Doesn't Matter</p></div> <p><strong>Resolution:</strong></p> <p>Doesn't matter, I don't think. I printed in .2.</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>Doesn't matter, I did 35%.</p></div> <p><strong>Filament:</strong> eSun PLA+ Black Post-Printing =============</p> <p>Depending on your device, and if you print it stock without modifications, you might need to sand it or clip the edges of the "stand" part for it to fit your device.</p> <p>If you've got the same amp as I do, or similar, it should slide right in.</p> <h3>How I Designed This</h3> <p>I took the excellent minimalist bookend by xyzaxis, and turned it on its side, lopped the end off, and made it thinner.</p> </p></p></p> Category: Pets