Cat Feeder Puzzle

thingiverse

A wildly over-engineered solution to a mundane problem. Saw an article stating that cats must play with their food to feel satisfied, and said, "Hold my beer." Pour food into the top funnel, and it disperses evenly throughout the puzzle level. The cat can see the food and bat it around, but cannot access it unless it pushes the food into the openings in the central tube. The food then falls down a level, either onto the plate or onto the next lower puzzle level if one exists. This model requires considerable plastic and time to print. Before commencing, print Screw_Test.stl to ensure your settings will produce functioning screw joints. If it fails to work, do not bother with the other pieces. Print 1 "plate", 1 "lid", and as many "puzzle" parts as desired (too many may cause instability). The pieces connect via screwing, but a spot of glue might be warranted. Supports are only necessary for the small rims parallel to the ground and in the windows, so set your supports to 80 degrees if using Cura. Some claim that printed PLA is not safe for consumption. If concerned, seek food-safe PLA or avoid this project. Also, you assume full responsibility for the safety of your pet! Ensure its head does not fit into the windows. Sand any sharp edges! Be cautious of breakage. I disclaim all liability for any consequences arising from your use of this model. If you do not agree to accept 100% responsibility, refrain from using this model!