Cat Corner Rub - 2hr 30g Vase Mode

thingiverse

I saw someone else post one and it reminded me I always wanted to make one ultra light versatile and vase mode! You print this with 0.4mm and 0.2mm layer height. with a 0.6mm nozzle if you scale it up slightly say 25% it should slice without busting vase mode (the ribs are dimensionally important in slicing) less than 2 hours to print less than 30g of plastic in vase mode no top no bottom layers. You can double stick tape to the wall or use the flat plates on the sides screw right through them into the wall.