cat armour

thingiverse

The original file wasn't changed but converted for my print to run through Repetire, same as the Kora Midi that uses gcode files. All sections are scaled by 80% and can be restored to 100%. Sections were rotated to put the longest edge on the bed and minimal supports used so the edges sit well. Original files used printed plastic pegs, but they didn't print well, so I replaced them with metal paper fasteners, and it works great. The cat wears it! Print Settings Printer: Kora Midi Rafts: No Supports: Yes Resolution: standard Infill: 20% Notes: PLA at 230 degrees Bed temperature is 50 degrees Kapton tape and spray adhesive on bed Minimal supports are set using repetire Post-Printing Simple finishing touches were made. Edges were lightly sanded where the supports came loose, a fine finish was achieved for this model.