Cat and Dog Pots (Self-Watering for Plants)

prusaprinters

A cat and dog to hold your little plant buddies. There's 3 different faces for each. Don't stare at the butthole too much. These have a self-watering feature. Use the included watering can or other pouring device and add water through the… backside. DON'T STARE AT IT TOO HARD.PrintingNo supports needed! Prints well at  0.20mm layer height and around 10% infill as it's a decorative piece. You can likely scale-up this model to larger sizes without an issues, but always check after slicing! If you like these models and want some other animals: Frog and Snake *Layer lines struck again on the dog :(. Don't worry, the model is safe, as seen by the cat.